Remanufactured injector, cross-ref 127-8216, 127-8218. Bench-tested before shipment.
Quote within 24 hours. Send a photo of your nameplate and we will confirm the exact match.
127-8216 is supplied as a remanufactured replacement injector. Cross-reference numbers: 127-8216, 127-8218. Application recorded for this part: Fits Caterpillar — 3116. Fuel is delivered to this injector already pressurised by the rail. What it contributes is timing and atomisation — opening and closing within milliseconds, several times per combustion event on modern engines. Small changes in spray pattern or opening behaviour show up quickly as noise, smoke and rising consumption. Watch for hard hot starting, uneven idle, visible smoke, a misfire that clears when the engine is revved, and consumption creeping up without any change in operating conditions. Before replacing anything, distinguish injector faults from their look-alikes. Comparing return volume between cylinders and running a cut-out test on a diagnostic tool will show which cylinder is actually contributing — cheap checks that prevent replacing parts that were not faulty. Fitting notes: replace as a set rather than singly. A lone new injector will deliver differently from the worn ones around it, which usually reproduces the rough running. Use new sealing washers every time, clean the injector bore and seat carefully, and check whether your engine management expects classification codes to be entered after installation. Rebuild process: full teardown and measurement first, then replacement of all wear components, machining back to specification where required, followed by calibration and bench testing. The difference between this and a cleaned used part is the measurement and test record — we hold every unit to the specification for the part number, not just to 'it runs'. Test sheets available on request, and every unit ships with a 12-month warranty.
| Part number | 127-8216 |
| Condition | Remanufactured (not a genuine OEM new part) |
| Cross-reference | 127-8216, 127-8218 |
| Application | Fits Caterpillar — 3116 |
| Process | Disassembled, cleaned, measured, wear parts replaced, machined to specification |
| Bench test | Delivery, return flow, opening pressure and leakage recorded before dispatch |
| Warranty | 12 months |
How to tell a failing common rail injector from compression, turbo and air-side faults — and why the cheap checks come first.
Read the guide →Three very different things are sold under similar descriptions. Here is what separates them, and what to ask before you buy.
Read the guide →What the digits on your injector actually mean, why several numbers fit the same part, and how to avoid ordering the wrong one.
Read the guide →
