About this part
232-1171 is supplied as a remanufactured replacement common rail injector. Cross-reference numbers: 232-1171, 2321171, 3142E. Application recorded for this part: Fits Caterpillar — CAT.
An injector is a high-speed valve. It has to hold back rail pressure, then open and close within a fraction of a crankshaft degree — several times per cycle on pilot-injection engines. Anything that alters opening behaviour, whether it is carbon on the tip, a worn needle or a tired solenoid, changes how the cylinder burns its charge.
Typical signs are poor starting hot or cold depending on whether the unit is weeping or sticking, an idle that hunts or sounds uneven, smoke under acceleration, and sometimes a smell of diesel in the oil where an injector is leaking internally.
A back-leakage comparison across the set is the cheapest meaningful test: uneven return between cylinders points at the failing unit. Follow it with a cut-out test to confirm which cylinder actually stops contributing.
Before fitting: clean the seat thoroughly, use new copper washers and seals, and torque the clamp to the engine manufacturer’s figure. Replace as a set where possible, and check whether the ECU needs the new units’ classification codes written in afterwards.
How we build it: the unit is fully disassembled, cleaned and measured, not simply resealed. Wear items — seals, springs, and where clearance is out of specification the plunger and barrel or nozzle assemblies — are replaced rather than reused. Sealing faces and bores are re-machined back to original clearances, then the unit is calibrated and run on a bench with delivery, return flow, opening pressure and leakage recorded. Anything outside specification does not ship. Test sheets for your specific units are available on request. Covered by a 12-month warranty.
Specifications
| Part number | 232-1171 |
| Condition | Remanufactured (not a genuine OEM new part) |
| Cross-reference | 232-1171, 2321171, 3142E |
| Application | Fits Caterpillar — CAT |
| Process | Disassembled, cleaned, measured, wear parts replaced, machined to specification |
| Bench test | Delivery, return flow, opening pressure and leakage recorded before dispatch |
| Warranty | 12 months |
Fitment note. Several part numbers in this family look similar. Confirm the number on your
existing unit, the engine model and the machine or vehicle application before ordering. Send us a nameplate photo
and we will verify the match before dispatch.
All manufacturer names, symbols and part numbers are used for identification and cross-reference purposes only. We are not an authorised distributor and are not affiliated with the original equipment manufacturer. Products offered are remanufactured or new aftermarket replacement parts unless stated otherwise.
