Remanufactured injector, cross-ref 374-0750. Bench-tested before shipment.
Quote within 24 hours. Send a photo of your nameplate and we will confirm the exact match.
374-0750 is supplied as a remanufactured replacement injector. Cross-reference numbers: 374-0750. Application recorded for this part: Fits Caterpillar — CAT 374D C15 C32. An injector is a high-speed valve. It has to hold back rail pressure, then open and close within a fraction of a crankshaft degree — several times per cycle on pilot-injection engines. Anything that alters opening behaviour, whether it is carbon on the tip, a worn needle or a tired solenoid, changes how the cylinder burns its charge. Common indicators are rough or unstable idle, smoke that was not there before, higher fuel consumption on the same duty cycle, diesel knock under load, and in some cases fuel dilution of the engine oil from an injector that is leaking internally. Before replacing anything, distinguish injector faults from their look-alikes. Comparing return volume between cylinders and running a cut-out test on a diagnostic tool will show which cylinder is actually contributing — cheap checks that prevent replacing parts that were not faulty. Before fitting: clean the seat thoroughly, use new copper washers and seals, and torque the clamp to the engine manufacturer’s figure. Replace as a set where possible, and check whether the ECU needs the new units’ classification codes written in afterwards. Rebuilt rather than refurbished: full teardown and measurement, worn components replaced instead of cleaned and reused, sealing surfaces restored to specification, then bench calibration and testing. The record is what separates this from a used part — we can provide the test sheet for your order. Covered by a 12-month warranty.
| Part number | 374-0750 |
| Condition | Remanufactured (not a genuine OEM new part) |
| Application | Fits Caterpillar — CAT 374D C15 C32 |
| Process | Disassembled, cleaned, measured, wear parts replaced, machined to specification |
| Bench test | Delivery, return flow, opening pressure and leakage recorded before dispatch |
| Warranty | 12 months |
How to tell a failing common rail injector from compression, turbo and air-side faults — and why the cheap checks come first.
Read the guide →Three very different things are sold under similar descriptions. Here is what separates them, and what to ask before you buy.
Read the guide →What the digits on your injector actually mean, why several numbers fit the same part, and how to avoid ordering the wrong one.
Read the guide →
