About this part
0445120231 is supplied as a remanufactured replacement common rail injector. Cross-reference numbers: 0445120231, PC200-8, PC220-8, 6D107. Application recorded for this part: Fits Komatsu.
The injector sits at the end of the rail and does the final metering work: it receives fuel already at high pressure and decides both how much enters the cylinder and how well atomised it is. That combination governs power, smoke and fuel consumption more directly than almost any other part on the engine.
Common indicators are rough or unstable idle, smoke that was not there before, higher fuel consumption on the same duty cycle, diesel knock under load, and in some cases fuel dilution of the engine oil from an injector that is leaking internally.
Before replacing anything, distinguish injector faults from their look-alikes. Comparing return volume between cylinders and running a cut-out test on a diagnostic tool will show which cylinder is actually contributing — cheap checks that prevent replacing parts that were not faulty.
Fitment notes: injectors on the same engine wear together. Replacing only the failed unit often leaves the others close behind, and a single new injector reading differently from its neighbours will cause exactly the rough running you were trying to fix. Replacing as a matched set avoids that. Always fit new copper sealing washers and seals — used washers rarely seal a second time — and where the system requires injector classification or IQA codes, have them programmed to the ECU after fitting.
Rebuilt rather than refurbished: full teardown and measurement, worn components replaced instead of cleaned and reused, sealing surfaces restored to specification, then bench calibration and testing. The record is what separates this from a used part — we can provide the test sheet for your order. Covered by a 12-month warranty.
Specifications
| Part number | 0445120231 |
| Condition | Remanufactured (not a genuine OEM new part) |
| Cross-reference | 0445120231, PC200-8, PC220-8, 6D107 |
| Application | Fits Komatsu |
| Process | Disassembled, cleaned, measured, wear parts replaced, machined to specification |
| Bench test | Delivery, return flow, opening pressure and leakage recorded before dispatch |
| Warranty | 12 months |
Fitment note. Several part numbers in this family look similar. Confirm the number on your
existing unit, the engine model and the machine or vehicle application before ordering. Send us a nameplate photo
and we will verify the match before dispatch.
All manufacturer names, symbols and part numbers are used for identification and cross-reference purposes only. We are not an authorised distributor and are not affiliated with the original equipment manufacturer. Products offered are remanufactured or new aftermarket replacement parts unless stated otherwise.
