DIESEL FUEL INJECTION · REMANUFACTURED & AFTERMARKET
Get a Quote
HomeFuel Pump › 580152470
Fuel Injection Pump 580152470
Fuel Injection Pump 580152470 view 1
Remanufactured

Fuel Injection Pump 580152470 for IVECO

Remanufactured fuel injection pump, cross-ref 580152470, 0445010586. Bench-tested before shipment.

Cross-reference / interchange numbers

5801524700445010586
Condition
Remanufactured — not a genuine OEM new part
Warranty
12 months
Testing
Bench-tested: injection quantity, return flow, opening pressure, leakage
Application
Fits IVECO — CP4
Request a Quote

Quote within 24 hours. Send a photo of your nameplate and we will confirm the exact match.

About this part

580152470 is supplied as a remanufactured replacement fuel injection pump. Cross-reference numbers: 580152470, 0445010586. Application recorded for this part: Fits IVECO — CP4. Every injection event depends on this pump producing pressure at exactly the right moment. Because it also carries its own lubrication, poor supply pressure and fuel dilution do disproportionate damage — which is why the supply side should always be checked alongside the pump itself. Typical indicators are progressively harder starting, particularly when hot, reduced power, smoke under load, erratic idle, and fuel dilution in the sump — the last one should always be investigated immediately. Before condemning the pump, rule out the cheap causes: supply restrictions, a weak lift pump, air ingress on the suction side and a blocked filter. Check supply pressure and condition at the pump inlet first, then look at delivery and timing. Key points: align to the timing marks rather than forcing the drive, prime before cranking, renew seals, confirm adequate supply pressure from the lift pump, and bleed the system fully. Skipping any of these is where most comebacks originate. Rebuild process: full teardown and measurement first, then replacement of all wear components, machining back to specification where required, followed by calibration and bench testing. The difference between this and a cleaned used part is the measurement and test record — we hold every unit to the specification for the part number, not just to 'it runs'. Test sheets available on request, and every unit ships with a 12-month warranty.

Specifications

Part number580152470
ConditionRemanufactured (not a genuine OEM new part)
Cross-reference580152470, 0445010586
ApplicationFits IVECO — CP4
ProcessDisassembled, cleaned, measured, wear parts replaced, machined to specification
Bench testDelivery, return flow, opening pressure and leakage recorded before dispatch
Warranty12 months
Fitment note. Several part numbers in this family look similar. Confirm the number on your existing unit, the engine model and the machine or vehicle application before ordering. Send us a nameplate photo and we will verify the match before dispatch.
All manufacturer names, symbols and part numbers are used for identification and cross-reference purposes only. We are not an authorised distributor and are not affiliated with the original equipment manufacturer. Products offered are remanufactured or new aftermarket replacement parts unless stated otherwise.

More part numbers for Iveco

Related technical guides

Related part numbers