Remanufactured fuel injection part, cross-ref 294000-3010. Bench-tested before shipment.
Quote within 24 hours. Send a photo of your nameplate and we will confirm the exact match.
294000-3010 is supplied as a remanufactured replacement fuel injection part. Cross-reference numbers: 294000-3010. In a common rail system the injector is the component that actually controls combustion. It holds back fuel at rail pressure and lifts for only a few milliseconds at a time, metering the exact quantity and breaking it into a fine spray so the charge ignites cleanly. When delivery drifts, the engine does not usually stop — it simply starts to burn fuel badly. Common indicators are rough or unstable idle, smoke that was not there before, higher fuel consumption on the same duty cycle, diesel knock under load, and in some cases fuel dilution of the engine oil from an injector that is leaking internally. Before replacing anything, distinguish injector faults from their look-alikes. Comparing return volume between cylinders and running a cut-out test on a diagnostic tool will show which cylinder is actually contributing — cheap checks that prevent replacing parts that were not faulty. Fitting notes: replace as a set rather than singly. A lone new injector will deliver differently from the worn ones around it, which usually reproduces the rough running. Use new sealing washers every time, clean the injector bore and seat carefully, and check whether your engine management expects classification codes to be entered after installation. Rebuild process: full teardown and measurement first, then replacement of all wear components, machining back to specification where required, followed by calibration and bench testing. The difference between this and a cleaned used part is the measurement and test record — we hold every unit to the specification for the part number, not just to 'it runs'. Test sheets available on request, and every unit ships with a 12-month warranty.
| Part number | 294000-3010 |
| Condition | Remanufactured (not a genuine OEM new part) |
| Process | Disassembled, cleaned, measured, wear parts replaced, machined to specification |
| Bench test | Delivery, return flow, opening pressure and leakage recorded before dispatch |
| Warranty | 12 months |
How to tell a failing common rail injector from compression, turbo and air-side faults — and why the cheap checks come first.
Read the guide →Three very different things are sold under similar descriptions. Here is what separates them, and what to ask before you buy.
Read the guide →What the digits on your injector actually mean, why several numbers fit the same part, and how to avoid ordering the wrong one.
Read the guide →
