Remanufactured injector assembly, cross-ref 28229873, 33800-4A710. Bench-tested before shipment.
Quote within 24 hours. Send a photo of your nameplate and we will confirm the exact match.
28229873 is supplied as a remanufactured replacement injector assembly. Cross-reference numbers: 28229873, 33800-4A710. Application recorded for this part: Fits Hyundai. An injector is a high-speed valve. It has to hold back rail pressure, then open and close within a fraction of a crankshaft degree — several times per cycle on pilot-injection engines. Anything that alters opening behaviour, whether it is carbon on the tip, a worn needle or a tired solenoid, changes how the cylinder burns its charge. What owners usually notice first: longer cranking, a rougher idle, more smoke than the engine used to produce, worse consumption, and occasionally a metallic knock that appears under load and clears once the engine is revved. Do a return-flow check before buying anything. Comparing leak-off volumes between cylinders takes minutes, and if one injector returns far more than its neighbours, that single test has answered the question. Fitting notes: replace as a set rather than singly. A lone new injector will deliver differently from the worn ones around it, which usually reproduces the rough running. Use new sealing washers every time, clean the injector bore and seat carefully, and check whether your engine management expects classification codes to be entered after installation. Rebuilt rather than refurbished: full teardown and measurement, worn components replaced instead of cleaned and reused, sealing surfaces restored to specification, then bench calibration and testing. The record is what separates this from a used part — we can provide the test sheet for your order. Covered by a 12-month warranty.
| Part number | 28229873 |
| Condition | Remanufactured (not a genuine OEM new part) |
| Cross-reference | 28229873, 33800-4A710 |
| Application | Fits Hyundai |
| Process | Disassembled, cleaned, measured, wear parts replaced, machined to specification |
| Bench test | Delivery, return flow, opening pressure and leakage recorded before dispatch |
| Warranty | 12 months |
How to tell a failing common rail injector from compression, turbo and air-side faults — and why the cheap checks come first.
Read the guide →Three very different things are sold under similar descriptions. Here is what separates them, and what to ask before you buy.
Read the guide →What the digits on your injector actually mean, why several numbers fit the same part, and how to avoid ordering the wrong one.
Read the guide →
