Remanufactured fuel injection part, cross-ref 104642-7632. Bench-tested before shipment.
Quote within 24 hours. Send a photo of your nameplate and we will confirm the exact match.
104642-7632 is supplied as a remanufactured replacement fuel injection part. Cross-reference numbers: 104642-7632. Application recorded for this part: VE. This is the last precision component in the fuel path. Everything upstream exists to deliver clean fuel at stable pressure; this unit decides when combustion starts and how completely the charge burns. That is why injector condition shows up so directly in noise, smoke and emissions. Symptoms that point to injector wear include hard starting when hot, rough idle, white smoke at start-up or black smoke under load, a sharp knocking from one cylinder, increased fuel consumption and a gradual loss of power. Before replacing anything, distinguish injector faults from their look-alikes. Comparing return volume between cylinders and running a cut-out test on a diagnostic tool will show which cylinder is actually contributing — cheap checks that prevent replacing parts that were not faulty. Installation notes: new copper washers and seals are mandatory, the seat must be clean and undamaged, and the retainers should be torqued to the engine manufacturer's specification. If the ECU stores injector codes for this engine, program them after fitting, otherwise the engine will not compensate correctly. How we build it: the unit is fully disassembled, cleaned and measured, not simply resealed. Wear items — seals, springs, and where clearance is out of specification the plunger and barrel or nozzle assemblies — are replaced rather than reused. Sealing faces and bores are re-machined back to original clearances, then the unit is calibrated and run on a bench with delivery, return flow, opening pressure and leakage recorded. Anything outside specification does not ship. Test sheets for your specific units are available on request. Covered by a 12-month warranty.
| Part number | 104642-7632 |
| Condition | Remanufactured (not a genuine OEM new part) |
| Application | VE |
| Process | Disassembled, cleaned, measured, wear parts replaced, machined to specification |
| Bench test | Delivery, return flow, opening pressure and leakage recorded before dispatch |
| Warranty | 12 months |
How to tell a failing common rail injector from compression, turbo and air-side faults — and why the cheap checks come first.
Read the guide →Three very different things are sold under similar descriptions. Here is what separates them, and what to ask before you buy.
Read the guide →What the digits on your injector actually mean, why several numbers fit the same part, and how to avoid ordering the wrong one.
Read the guide →
