DIESEL FUEL INJECTION · REMANUFACTURED & AFTERMARKET
Get a Quote
HomeFuel Pump › 0460414267
Fuel Injection Pump 0460414267
Fuel Injection Pump 0460414267 view 1
Remanufactured

Fuel Injection Pump 0460414267

Remanufactured fuel injection pump, cross-ref 0460414267, 504251950. Bench-tested before shipment.

Cross-reference / interchange numbers

0460414267504251950
Condition
Remanufactured — not a genuine OEM new part
Warranty
12 months
Testing
Bench-tested: injection quantity, return flow, opening pressure, leakage
Application
VE
Request a Quote

Quote within 24 hours. Send a photo of your nameplate and we will confirm the exact match.

About this part

0460414267 is supplied as a remanufactured replacement fuel injection pump. Cross-reference numbers: 0460414267, 504251950. Application recorded for this part: VE. The injection pump is what generates injection pressure and meters fuel to each cylinder in firing order. Because it also provides the timing reference, its condition affects starting, smoke, power and fuel consumption together — a pump that is worn rarely produces a single isolated symptom. Symptoms associated with pump wear include hard starting when hot, loss of power, unstable idle, excess smoke, timing that will not hold, and in some cases diesel getting into the lubricating oil via a leaking drive shaft seal. Before condemning the pump, rule out the cheap causes: supply restrictions, a weak lift pump, air ingress on the suction side and a blocked filter. Check supply pressure and condition at the pump inlet first, then look at delivery and timing. Fitting notes: timing is everything here. Set the pump against the engine's timing marks rather than forcing anything, prime thoroughly before cranking, and check that the lift pump is delivering adequate supply pressure. Also replace the mounting seal and confirm there is no air left in the system before the first start. How we build it: the unit is fully disassembled, cleaned and measured, not simply resealed. Wear items — seals, springs, and where clearance is out of specification the plunger and barrel or nozzle assemblies — are replaced rather than reused. Sealing faces and bores are re-machined back to original clearances, then the unit is calibrated and run on a bench with delivery, return flow, opening pressure and leakage recorded. Anything outside specification does not ship. Test sheets for your specific units are available on request. Covered by a 12-month warranty.

Specifications

Part number0460414267
ConditionRemanufactured (not a genuine OEM new part)
Cross-reference0460414267, 504251950
ApplicationVE
ProcessDisassembled, cleaned, measured, wear parts replaced, machined to specification
Bench testDelivery, return flow, opening pressure and leakage recorded before dispatch
Warranty12 months
Fitment note. Several part numbers in this family look similar. Confirm the number on your existing unit, the engine model and the machine or vehicle application before ordering. Send us a nameplate photo and we will verify the match before dispatch.
All manufacturer names, symbols and part numbers are used for identification and cross-reference purposes only. We are not an authorised distributor and are not affiliated with the original equipment manufacturer. Products offered are remanufactured or new aftermarket replacement parts unless stated otherwise.

Related technical guides

Related part numbers