About this part
0432131752 is supplied as a remanufactured replacement injector. Cross-reference numbers: 0432131752, RE64184, 8200T. Application recorded for this part: Fits John Deere — 8210 John Deere.
In a common rail system the injector is the component that actually controls combustion. It holds back fuel at rail pressure and lifts for only a few milliseconds at a time, metering the exact quantity and breaking it into a fine spray so the charge ignites cleanly. When delivery drifts, the engine does not usually stop — it simply starts to burn fuel badly.
Typical signs are poor starting hot or cold depending on whether the unit is weeping or sticking, an idle that hunts or sounds uneven, smoke under acceleration, and sometimes a smell of diesel in the oil where an injector is leaking internally.
Because those symptoms also point to compression, turbocharger or air-side problems, it is worth confirming before ordering. A return-flow (back-leakage) test across all injectors and a cylinder cut-out test will usually identify both whether the fault is injector-related and which cylinder is responsible.
Fitting notes: replace as a set rather than singly. A lone new injector will deliver differently from the worn ones around it, which usually reproduces the rough running. Use new sealing washers every time, clean the injector bore and seat carefully, and check whether your engine management expects classification codes to be entered after installation.
Rebuilt rather than refurbished: full teardown and measurement, worn components replaced instead of cleaned and reused, sealing surfaces restored to specification, then bench calibration and testing. The record is what separates this from a used part — we can provide the test sheet for your order. Covered by a 12-month warranty.
Specifications
| Part number | 0432131752 |
| Condition | Remanufactured (not a genuine OEM new part) |
| Cross-reference | 0432131752, RE64184, 8200T |
| Application | Fits John Deere — 8210 John Deere |
| Process | Disassembled, cleaned, measured, wear parts replaced, machined to specification |
| Bench test | Delivery, return flow, opening pressure and leakage recorded before dispatch |
| Warranty | 12 months |
Fitment note. Several part numbers in this family look similar. Confirm the number on your
existing unit, the engine model and the machine or vehicle application before ordering. Send us a nameplate photo
and we will verify the match before dispatch.
All manufacturer names, symbols and part numbers are used for identification and cross-reference purposes only. We are not an authorised distributor and are not affiliated with the original equipment manufacturer. Products offered are remanufactured or new aftermarket replacement parts unless stated otherwise.
